V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Cabling
OPTION
0...40 kHz
IF
4. Connection of a FET analyzer
Note:
If the optional IF Converter R&S UX 895 is
installed, interface IF 0...40!kHz will also
provide the 455>kHz intermediate fre>
quency.
Connect the recessed BNC socket via an RF
cable to an analyzing device (e.g. analyzer
FET).
Configure the IF signal acc. to 3.1.19.11
(local operation) or via the 25>way con>
nector strip RS232C>RS485 acc. to A3.8.6.
As the mating contact we recommend a
straight BNC cable plug (FJ 075.8421). In
connection with the recommended mat>
ing contact the 75>] coaxial cable
(DH!025.2142) can be used.
5. Connection of a spectrum display
(option)
Note:
For this the optional IF Processor
R&S GM!893, model 03 is required.
Connect the recessed BNC socket via an RF
cable to an analyzing device (e.g. Spec>
trum Display EPY 513).
As the mating contact we recommend to
use a straight BNC cable connector
(FJ!075.8421). In connection with the
recommended mating contact the 75>]
coaxial cable (DH 025.2142) can be used.
6164.0717.02_01
> 2.9 >
To Next Page
Loading...
