V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Special Functions
A3.7.10 Storage into a Channel
Command syntax:
Code: ST
Parameter: .................... a
Possible entry
Range: .......................... 0 to 999
Example:
Storing the currently effective receiver setting
into channel 873
Command = rAxxST873?
A3.7.11 Channel Call>up
Command syntax:
Code: K
Parameter: .................... a,b
z: ................................... s (set)
Possible entry
Range: .......................... 0 to 999
Note:
Inhibited channels (K<parameter>,e; see
A3.7.13) are automatically reactivated upon
command Ks,<parameter>, that is, the flag
'e' is cancelled.
Example:
Activating channel 873
Command = rAxxKs,873?
Æ Operating mode CHANNEL
A3.7.12 Editing the Channel
Contents
Command syntax:
Code: K
Parameter: .................... a
Possible entry
Range: .......................... 0 to 999
Note:
The code K without parameter 's' in the com>
mand block means, that all receiver settings
following the K are not carried out directly, but
are only stored under the respective channel
number.
The receiver status is not affected by the com>
mand K<parameter>.
Example 1:
Program channel 125 as follows:
f Frequency: 6 MHz = F6000000
f Modulation mode: CW = I5
f Control type: AGC+DGC = R1
f Control time: 500 ms = DT2
f Bandwidth: 150 Hz = W1
f BFO frequency: 800 Hz = B800
f DGC value: 45 dBoV
EMF
= D45
Command =
rAxxK125F6000000I5R1DT2W1B800D45?
Example 2 (with option EK 895S7):
Program channel 125 as follows:
f Frequency: 6 MHz = F6000000
f Modulation mode: CW = I5
f Control type: AGC+DGC = R1
f Control time: 500 ms = DT2
f Bandwidth: 1200 Hz = Q1200,1
f BFO frequency: 800 Hz = B800
f DGC value: 45 dBoV
EMF
= D45
Command =
rAxxK125F6000000I5R1DT2Q1200,1
B800D45?
6164.0717.02_01
> A3.29 >
To Next Page
Loading...
