V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Replacement of Modules
4.3.4 Control Unit (R&S EK 896)
Removal
1. Make preparations acc. to 4.3.1.
2. Undo and remove four screws (see Fig. 4.9)
fixing the control unit.
3. Carefully pull control unit out to the front
until male connector X20 (see Fig. 4.4) and
male connector strip X5 become accessible.
4. Disconnect female connector from X20.
5. Disconnect female connector from 3>way
male connector X5.
6. Pull control unit completely out and
remove.
Installation
Installation is to be carried out in the reverse
order of removal.
Fig. 4.4 Location of Connectors X5 and X20 (Control Unit)
6164.0717.02_01
> 4.25 >
To Next Page
Loading...
