V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Master / Slave Operation
3.1.23 Master / Slave Operation (R&S EK 896)
Via the master!/!slave menu the operator can
make up to 14 receivers (e.g. R&S EK 895),
which are interconnected via an RS485 bus, his
slave receivers.
For this it is only necessary to actuate key PUT
and enter the slave address.
Five freely programmable addresses can be
selected via the softkeys. Entry of addresses 1
to 9 is possible directly via the numeric keypad.
Via the command PUT the receiver (Æ slave)
with the entered address takes over the
current master receiver setting.
Note:
Via the command PUT only the basic receiver
settings, consisting of frequency, BFO fre>
quency, passband tuning, bandwidth, modula>
tion mode as well as control type and time are
transferred to the slave receiver.
In contrast, scanning commands and para>
meters as well as system and special functions
are not transmitted from the master to the
slave receiver. Therefore it is, for example,
neither possible to program a scanning process
nor to start a scan run which has been pro>
grammed.
It is also possible that one's own receiver (Æ
master) takes over the setting of the slave
receiver with the entered address via the
command GET.
3.1.23.1 Transferring the Master Receiver
Setting
Upon actuation of key PUT the following
display appears:
SELECT ADR 11 23 56 67 98>
11, 23, 56, 67 and 98 are the last stored slave
addresses (= selection menu).
Actuate either a key of the numeric keypad (1
to 9) or a softkey.
3.1.23.2 Calling Up the Slave Receiver
Setting
Upon actuation of key GET it appears the
following display:
SELECT ADR 11 23 56 67 98>
11, 23, 56, 67 and 98 are the last stored slave
addresses (= selection menu).
Actuate either a key of the numeric keypad (1
to 9) or a softkey.
3.1.23.3 Programming a Slave Address
Upon actuation of key GET or PUT and then
MORE the following is displayed:
PROGRAMME 11 23 56 67 98
11, 23, 56, 67 and 98 are the last stored slave
addresses (= programming menu).
Upon actuation of the softkey which is
assigned to the address to be altered, the
following display appears:
SLAVE ADR _
The flashing cursor (_) indicates that an entry is
being expected. Enter the new slave address
via the numeric keypad.
Range of entry: ............ 1 to 99
6164.0717.02_01
> 3.66 >
To Next Page
Loading...
