Rohde & Schwarz 890 Series - Control Unit 1 ∫REMOTE∫ (R&S EK 895)

V L F > H F R E C E I V E R S f R & S E K 8 9 5 / R & S E K 8 9 6
User Manual f Replacement of Modules
4.3.2 Control Unit 1 ∫REMOTE∫ (R&S EK 895)
Removal
1. Make preparations acc. to 4.3.1.
2. Undo and remove four screws (1a, Fig. 4.8)
fixing the control unit 1.
3. Carefully pull control unit 1 out to the
front until male connector X20 (see Fig.
4.2) becomes accessible.
4. Push off locking devices on left and right.
5. Pull off female connector strip.
6. Pull control unit 1 completely out and
remove.
Installation
Installation is to be carried out in the reverse
order of removal.
Fig. 4.2 Location of Connector X20 (Control Unit 1)
6164.0717.02_01
> 4.23 >