V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Installation
2.4 Installation
2.4.1 General
The VLF>HF receivers are designed for oper>
ation under adverse environmental conditions
without impairing their characteristics. The vi>
brations encountered in normal transport will
not detract from their functioning. For the en>
vironmental conditions the limit values stated
in the data sheet apply.
The VLF>HF receivers are suitable to be used in
both stationary and mobile operation.
The VLF>HF receivers are supplied as desk>top
models. By using the optional 19∫ Service Kit
R&S ZZA>98 (for one R&S EK 895) or Parts Set
R&S KA!890L1 (for two R&S EK 895), installa>
tion into a 19∫ rack is also possible.
The installation into such a rack can be carried
out in a fix manner or with the aid of telescopic
rails.
For mobile applications we recommend to use
a shockmount, e.g. for R&S EK!895:
R&S KS 890C1 or R&S KS!890M1 (MIL>STD>
810D). In this case make sure that the selected
shockmount is able to fulfil the requirements
of the respective application.
When installing the VLF>HF receivers, make
sure that the following is taken care of:
f Make sure that enough space is available is
front of the respective receiver for its local
control, if need be.
Fig. 2.1 Possible Positions for Installation
6164.0717.02_01
> 2.3 >
To Next Page
Loading...
