V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Safety Notes
2. Preparation for Use
2.1 Safety Notes
In the setting up of premises for the operation
of electrical installations and in the setting up
and operation of the installations themselves,
the relevant national or international safety
regulations and requirements should be ob>
served and maintained.
The essence of these are contained in the
safety guidelines of the IEC 364, in VDE 0100
(= DIN 57100) and DIN 57800.
They cover the following aspects:
a) Protective measures:
f accident prevention
f protection against excessive voltage
f insulation of installations
f grounding
b) Nature and laying of lines and cables
c) Rules for operating facilities and installa>
tions of a special kind:
f premises for the installation of electri>
cal installations
f charging stations and charging devices
for batteries
W A R N I N G
The VLF>HF receivers operate on an AC
mains voltage of 100 VAC, 120 VAC,
220 VAC or 240!VAC. This voltage is a
life hazard.
When dealing with this voltage be ex>
tremely careful and take appropriate
safety measures!
2.2 Unpacking and
Checking
f Unpack the respective VLF>HF receiver.
f Check whether the packing is damaged. If
so, check whether the unit is also damaged.
In this case, please notify the forwarding
agency immediately.
Note:
We recommend to keep the packing for
later service purposes.
f Check whether the options you ordered
are installed (see Fig. 2.25 (R&S EK 895) or
Fig. 2.26 (R&S EK 896)).
6164.0717.02_01
> 2.1 >
To Next Page
Loading...
