Rohde & Schwarz 890 Series - Bandwidth; Selecting a Bandwidth (R&S EK 895)

V L F > H F R E C E I V E R S f R & S E K 8 9 5 / R & S E K 8 9 6
User Manual f Bandwidth
3.1.9 Bandwidth
3.1.9.1 Selecting a Bandwidth
(R&S EK 895)
By actuating particular softkeys while in the
bandwidth selection menu the operator can
select between 17 bandwidths. The currently
effective bandwidth is indicated in the band>
width field.
The following bandwidths (indications) are
possible:
f 150 Hz (0.1)
f 300 Hz (0.3)
f 400 Hz (0.4)
f 600 Hz (0.6)
f 800 Hz (0.8)
f 1 kHz (1.0)
f 1.5 kHz (1.5)
f 1.8 kHz (1.8)
f 2.1 kHz (2.1)
f 2.4 kHz (2.4)
f 2.7 kHz (2.7)
f 3.1 kHz (3.1)
f 3.6 kHz (3.6)
f 4.0 kHz (4.0)
f 4.8 kHz (4.8)
f 6 kHz (6.0)
f 8 kHz (8.0)
Note:
Depending on the set modulation mode, only
certain bandwidths can be set resp. only these
bandwidths make sense:
FM: f 4 kHz
ISB: 2.1 to 3.1 kHz
SSB: 150 Hz to 3.6 kHz
2.7 kHz (for data link models)
In order to move to the next larger bandwidth
actuate
softkey BW>.
In order to move to the next smaller band>
width actuate
softkey BW=.
Actuate the relevant softkey several times, if
need be, until the desired bandwidth is indi>
cated.
Once the maximum or minimum value is
reached, the display does not change any more
for further actuation of the relevant softkey.
6164.0717.02_01
> 3.18 >