Rohde & Schwarz 890 Series - Installation into a 19 Rack; Preparations

V L F > H F R E C E I V E R S f R & S E K 8 9 5 / R & S E K 8 9 6
User Manual f Installation into a 19" Rack
2.4.2 Installation into a 19∫ Rack
(see Fig. 2.25)
Note:
If one VLF>HF Receiver R&S EK 895 is to be installed into a 19∫ Rack, the 19∫>Service Kit R&S ZZA>98
(Rohde&Schwarz 827.4533) is required. For installation of two VLF>HF receivers into a 19∫ rack the
Parts Set R&S KA!890L1 (Rohde&Schwarz 6041.6699.03) should be used. If one VLF>HF Receiver
R&S EK 896 is to be installed into a 19∫ rack, the 19∫>Service Kit R&S ZZA>93 (R&S 396.4892) is
required. The following tools are necessary:
Screw drivers for Phillips screws, sizes 0, 1 and 2
Allan key (SW 2.5 mm)
2.4.2.1 Preparations
1. Remove spreaders in front stands (1) of re>
ceiver by means of screw driver for Phillips
screws.
2. Remove front stands of receiver.
3. Remove threaded studs in rear stands (2)
by means of Allan key.
4. Remove rear stands of receiver.
5. Remove all lateral stands (3).
Fig. 2.2 Removal of Stands
6164.0717.02_01
> 2.4 >