V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Replacement of Modules
4.3.6 Synthesizer
Removal
1. Make preparations acc. to 4.3.1.
2. Pull off socket on RF cable W4 (see Fig.
4.14) connected to plug X41.
3. Without option:
Pull off socket on RF cable W2 connected to
plug X42.
With option 'IF Processor R&S GM 893':
Pull off socket on RF cable W21 / W25 (see
Fig. 4.15) connected to plug X42.
4. Pull off socket on RF cable W3 connected to
plug X43 (see Fig. 4.14).
5. Pull of socket on RF cable W6 connected to
plug X44.
6. Pull off socket on RF cable W5 connected to
plug X45.
7. Open blue extracting levers on synthesizer
(see Fig. 4.12 (R&S EK 895) or Fig. 4.13 (R&S
EK 896).
8. Pull out synthesizer by taking hold of blue
levers.
Installation
Installation is to be carried out in the reverse
order of removal.
6164.0717.02_01
> 4.27 >
To Next Page
Loading...
