V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Channel Scanning with Freely Programmable Channel List
A3.6 Channel Scanning with Freely Programmable Channel List
In the operating modes MANUAL and CHANNEL it is possible to
f start channel scanning
or
to alter the scan process via the following codes (parameters):
f CH (channel list, up to 20 channels)
f DWC (dwell time)
f HTC (hold time)
In the operating mode CHANNEL SCANNING with freely programmable channel list the operator
can
f stop an active channel scanning process
or
f reactivate a stopped channel scanning process.
A3.6.1 Start Channel Scanning
Command syntax:
Code: STC
Example:
Starting a channel scanning process which has
already been programmed
Command = rAxxSTC?
Æ operating mode CHANNEL SCANNING with
freely programmable channel list
A3.6.2 Stop Channel Scanning
Command syntax:
Code: STO
Example:
Stopping a running scanning process
Command = rAxxSTO?
Æ operating mode CHANNEL (see A3.2.3)
A3.6.3 Resume Channel Scanning
Command syntax:
Code: CO
Possible replies
Parameter: ................... a
0 = no scanning
1 = frequency scanning
3 = channel scanning with freely pro>
grammed channel list
4 = channel scanning
Example 1:
Inquiry which scan process was last active
Command = rAxxCO??
Æ Reply = rAxxCO3?
Channel scanning with freely programmed
channel list was active.
Example 2:
Reactivating a stopped channel scanning pro>
cess
Command = rAxxCO?
Æ operating mode CHANNEL SCANNING with
freely programmed channel list
6164.0717.02_01
> A3.20 >
To Next Page
Loading...
