V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Basic Settings
A3.3.9 Programming Examples
Example 1:
The unaddressed VLF>HF receiver is to be set to the following basic values:
f Frequency: 801 kHz = F801000
f Type of modulation: AM = I1
f Bandwidth: 8 kHz = W80
f Control type: AGC = R0
f Control time: 150 ms = DT1
At the same time the setting is to be acknowledged.
Command: rF801000,?I1,?W80,?R0,?DT1,??
Æ Reply: rF801000I1W80R0DT1?
Example 2:
The VLF>HF receiver with the address 15 is to be set to the following basic values:
f Frequency: 6.1 MHz = F6100000
f Modulation mode: CW = I5
f BFO frequency: 1 kHz = B1000
f Bandwidth: 150 Hz = W1
At the same time the setting is to be acknowledged.
Command: rA15F6100000,?I5,?B1000,?W1,??
Æ Reply: rA15F6100000I5B1000W1?
Example 3:
The VLF>HF receiver with address 15 and option R&S EK 895S7 is to be set to the following basic
values:
f Frequency: 6.1 MHz = F6100000
f Modulation mode: CW = I5
f BFO frequency: 1 kHz = B1000
f Quasi>continuous bandwidth: 1200 Hz = Q1200,1
At the same time the setting is to be acknowledged.
Command: rA15F6100000,?I5,?B1000,?Q1200,1,??
Æ Reply: rA15F6100000I5B1000Q1225?
6164.0717.02_01
> A3.10 >
To Next Page
Loading...
