Rohde & Schwarz R&S RTB2004 - Page 333

Remote Control Commands
R&S
®
RTB2000
325User Manual 1333.1611.02 ─ 04
Usage: Setting only
15.8.1.2 Actions on Violation
MASK:ACTion:SOUNd:EVENt:MODE.............................................................................. 325
MASK:ACTion:STOP:EVENt:MODE................................................................................ 325
MASK:ACTion:SCRSave:EVENt:MODE...........................................................................325
MASK:ACTion:WFMSave:EVENt:MODE.......................................................................... 325
MASK:ACTion:PULSe:EVENt:MODE...............................................................................325
MASK:ACTion:STOP:EVENt:COUNt................................................................................325
MASK:ACTion:SCRSave:DESTination............................................................................. 326
MASK:ACTion:WFMSave:DESTination............................................................................ 326
MASK:ACTion:YOUT:ENABle......................................................................................... 326
MASK:ACTion:SOUNd:EVENt:MODE <EventMode>
MASK:ACTion:STOP:EVENt:MODE <EventMode>
MASK:ACTion:SCRSave:EVENt:MODE <EventMode>
MASK:ACTion:WFMSave:EVENt:MODE <EventMode>
MASK:ACTion:PULSe:EVENt:MODE <EventMode>
Defines when and how often the action is executed.
●
SOUNd: Generates a beep sound on mask violation.
●
STOP: Stops the waveform acquisition, after mask is violated for a defined number
of times. You can set how many times with the command MASK:ACTion:STOP:
EVENt:COUNt.
●
PULSe: Creates a pulse on the AUX OUT connector. This selection sets the con-
figuration of the AUX OUT connector to "Mask Violation".
●
SCRSave: Saves a screenshot on mask violation. To set path and filename of the
screenshot, use MASK:ACTion:SCRSave:DESTination.
●
WFMSave: Saves the waveform data on mask violation. To set path and filename
of the data file, use MASK:ACTion:WFMSave:DESTination.
Parameters:
<EventMode> OFF | EACH
OFF
No action is executed.
EACH
The selected action is executed on each violation of the mask.
*RST: OFF
MASK:ACTion:STOP:EVENt:COUNt <EventCount>
Sets the number of mask violations after which the action is executed.
Parameters:
<EventCount> Integer value, number of the violations that executes the action.
Applications