Rohde & Schwarz R&S RTB2004 - Page 395

Remote Control Commands
R&S
®
RTB2000
387User Manual 1333.1611.02 ─ 04
TRIGger:A:I2C:POFFset <PatternByteOffset>
Sets the number of bytes before the first byte of interest, relating to the end of the
address bytes.
Parameters:
<PatternByteOffset> Number of ignored bytes
Range: 0 to 4095
Increment: 1
*RST: 0
15.11.3.3 I²C - Decode Results
In all BUS<b>:I2C... commands, the suffix <b> selects the bus.
BUS<b>:I2C:FCOunt?....................................................................................................387
BUS<b>:I2C:FRAMe<n>:DATA?..................................................................................... 387
BUS<b>:I2C:FRAMe<n>:STATus?.................................................................................. 388
BUS<b>:I2C:FRAMe<n>:STARt?.................................................................................... 388
BUS<b>:I2C:FRAMe<n>:STOP?..................................................................................... 388
BUS<b>:I2C:FRAMe<n>:AACCess?................................................................................389
BUS<b>:I2C:FRAMe<n>:ACCess?..................................................................................389
BUS<b>:I2C:FRAMe<n>:ACOMplete?............................................................................. 389
BUS<b>:I2C:FRAMe<n>:ADBStart?................................................................................ 390
BUS<b>:I2C:FRAMe<n>:ADDRess?................................................................................390
BUS<b>:I2C:FRAMe<n>:ADEVice?.................................................................................390
BUS<b>:I2C:FRAMe<n>:AMODe?.................................................................................. 391
BUS<b>:I2C:FRAMe<n>:ASTart?....................................................................................391
BUS<b>:I2C:FRAMe<n>:BCOunt?.................................................................................. 391
BUS<b>:I2C:FRAMe<n>:BYTE<o>:ACCess?................................................................... 392
BUS<b>:I2C:FRAMe<n>:BYTE<o>:ACKStart?................................................................. 392
BUS<b>:I2C:FRAMe<n>:BYTE<o>:COMPlete?................................................................392
BUS<b>:I2C:FRAMe<n>:BYTE<o>:STARt?..................................................................... 393
BUS<b>:I2C:FRAMe<n>:BYTE<o>:VALue?..................................................................... 393
BUS<b>:I2C:FCOunt?
Returns the number of received frames.
Suffix:
<b>
.
1 | 2
Return values:
<FrameCount> Total number of decoded frames.
Usage: Query only
BUS<b>:I2C:FRAMe<n>:DATA?
Returns the data words of the specified frame.
Serial Bus Analysis