Rohde & Schwarz R&S RTB2004 - Page 415

Remote Control Commands
R&S
®
RTB2000
407User Manual 1333.1611.02 ─ 04
TRIGger:A:CAN:FORMerror <FormError>
Triggers on form errors. A form error occurs when a fixed-form bit field contains one or
more illegal bits.
The command is relevant if TRIGger:A:CAN:TYPE is set to ERRCondition.
Parameters:
<FormError> ON | OFF
*RST: OFF
15.11.5.3 CAN - Decode Results
In all BUS<b>:CAN... commands, the suffix <b> selects the bus.
BUS<b>:CAN:FCOunt?.................................................................................................. 407
BUS<b>:CAN:FRAMe<n>:TYPE?....................................................................................407
BUS<b>:CAN:FRAMe<n>:STATus?................................................................................ 408
BUS<b>:CAN:FRAMe<n>:STARt?...................................................................................408
BUS<b>:CAN:FRAMe<n>:STOP?................................................................................... 409
BUS<b>:CAN:FRAMe<n>:DATA?................................................................................... 409
BUS<b>:CAN:FRAMe<n>:ACKState?..............................................................................409
BUS<b>:CAN:FRAMe<n>:ACKValue?............................................................................. 409
BUS<b>:CAN:FRAMe<n>:CSSTate?...............................................................................410
BUS<b>:CAN:FRAMe<n>:CSValue?............................................................................... 410
BUS<b>:CAN:FRAMe<n>:DLCState?.............................................................................. 410
BUS<b>:CAN:FRAMe<n>:DLCValue?............................................................................. 411
BUS<b>:CAN:FRAMe<n>:IDSTate?................................................................................ 411
BUS<b>:CAN:FRAMe<n>:IDTYpe?................................................................................. 411
BUS<b>:CAN:FRAMe<n>:IDValue?.................................................................................411
BUS<b>:CAN:FRAMe<n>:BSEPosition?.......................................................................... 412
BUS<b>:CAN:FRAMe<n>:BCOunt?.................................................................................412
BUS<b>:CAN:FRAMe<n>:BYTE<o>:STATe?................................................................... 412
BUS<b>:CAN:FRAMe<n>:BYTE<o>:VALue?................................................................... 413
BUS<b>:CAN:FCOunt?
Returns the number of received frames.
Suffix:
<b>
.
1 | 2
Return values:
<FrameCount> Total number of decoded frames.
Usage: Query only
BUS<b>:CAN:FRAMe<n>:TYPE?
Returns the type of the specified frame.
Serial Bus Analysis