Remote Control
R&S
®
RTM20xx
308User Manual 1317.4726.02 ─ 01
Parameters:
<Field> EVEN | ODD | ALL | LINE | ALINe
EVEN | ODD
Triggers only on the field start of even or odd fields. Only available
for interlaced scanning.
ALL
All fields, triggers on the frame start (progressive scanning) or any
field start (interlaced scanning).
LINE
Triggers on the beginning of a specified line in any field. The line
number is set with TRIGger:A:TV:LINE.
ALINe
Triggers on the beginning of all video signal lines.
*RST:
ALL
TRIGger:
A:TV:LINE <Line>
Sets an exact line number if TRIGger:A:TV:FIELd is set to LINE.
Parameters:
<Line> Range: 1 to 525 (NTSC, PAL-M); 625 (PAL, SECAM, SDTV
I-576); 750 (HDTV P720); 1125 (HDTV I1080, HDTV
P1080)
Increment: 1
*RST: 1
15.2.5.5 Pattern Trigger
Pattern
TRIGger:A:PATTern:SOURce <SourceString>
Parameters:
<SourceString> string containing 0, 1, or X for each channel
1: high, the signal voltage is higher than the trigger level.
0: low, the signal voltage is lower than the trigger level.
X: Don't care. the channel does not affect the trigger.
Without MSO option, the pattern has 4 or 2 bits, depending on the
number of channels: <ch1><ch2>[<ch3><ch4>].
With MSO option, the pattern has 18 or 20 bits:
<ch1><ch2>[<ch3><ch4>]<d0><d1><d2>...<d15>.
Example:
Without MSO option R&S RTM-B1:
TRIG:A:PATT:SOUR "1X10"
CH1, CH3, and NOT CH4 are logically combined with
TRIGger:A:PATTern:FUNCtion, CH2 does not matter (don't
care).
Command Reference
To Next Page
Loading...
