Rohde & Schwarz RTM2032 - Page 324

Remote Control
R&S
®
RTM20xx
309User Manual 1317.4726.02 ─ 01
Example:
With MSO option R&S RTM-B1:
TRIG:A:PATT:SOUR "XXXX111101010011XXXX"
Analog channels CH1 to CH4 do not matter (don't care). Digital
channels D0 to D15 are logically combined with TRIGger:A:
PATTern:FUNCtion.
TRIGger:A:PATTern:FUNCtion <Function>
Sets the logical combination of the trigger states of the channels.
Parameters:
<Function> AND | OR
AND
The required states of all channels must appear in the input signal
at the same time.
OR
At least one of the channels must have the required state.
*RST: AND
TRIGger:A:PATTern:CONDition <ConditionString>
Sets the trigger point depending on the result of the logical combination of the channel
states.
Parameters:
<ConditionString> "TRUE" | "FALSE"
*RST: "TRUE"
Time Limitation
TRIGger:A:PATTern:MODE <PatternMode>
Disables the time limitation or sets the time comparison mode.
Parameters:
<PatternMode> OFF | TIMeout | WIDTh
OFF
Disables the time limitation.
TIMeout
Defines how long at least the result of the state pattern condition
must be true or false.
WIDTh
Defines a time range for keeping up the true result of the pattern
condition. The range is defined using TRIGger:A:PATTern:
WIDTh:RANGe.
Command Reference