Remote Control
R&S
®
RTM20xx
310User Manual 1317.4726.02 ─ 01
TRIGger:A:PATTern:WIDTh:RANGe <PatternRange>
Selects how the time limit of the pattern state is defined.
The time is specified using TRIGger:A:PATTern:WIDTh[:WIDTh] on page 310, the
range around is specified using TRIGger:A:PATTern:WIDTh:DELTa on page 310.
Parameters:
<PatternRange> WITHin | OUTSide | SHORter | LONGer
WITHin
Triggers if the pattern state remains unchanged longer than Time
- Delta and shorter than Time + Delta.
OUTSide
Triggers if the pattern state remains unchanged either shorter than
Time - Delta or longer than Time + Delta.
SHORter | LONGer
Triggers if the pattern state changes before or after the specified
time.
TRIGger:A:PATTern:WIDTh[:WIDTh] <PatternWidth>
For the ranges WITHin and
OUTSide, the <PatternWidth> defines the center of
a range
which is defined by the limits ±<Delta>.
For the ranges SHORter and LONGer, the pattern width defines the maximum and min-
imum values, respectively.
Parameters:
<PatternWidth> Default unit: s
TRIGger:A:PATTern:WIDTh:DELTa <PatternDelta>
Defines a range around the pattern width value specified using TRIGger:A:
PATTern:WIDTh[:WIDTh].
Parameters:
<PatternDelta> Default unit: s
15.2.5.6 Rise Time / Fall Time Trigger
TRIGger:A:LEVel<n>:RISetime:LOWer............................................................................311
TRIGger:A:LEVel<n>:RISetime:UPPer.............................................................................311
TRIGger:A:RISetime:SLOPe...........................................................................................311
TRIGger:A:RISetime:RANGe..........................................................................................311
TRIGger:A:RISetime:TIME..............................................................................................311
TRIGger:A:RISetime:DELTa............................................................................................312
Command Reference
To Next Page
Loading...
