Remote Control
R&S
®
RTM20xx
409User Manual 1317.4726.02 ─ 01
TRIGger:A:CAN:ICONdition <IdentifierCondition>
Sets the comparison condition: If the pattern contains at least one X (don't care), you can
trigger on values equal or not equal to the specified value. If the pattern contains only 0
and 1, you can also trigger on a range greater than or lower than the specified value.
The command is relevant if TRIGger:A:CAN:TYPE is set to ID or IDDT.
Parameters:
<IdentifierCondition> EQUual | NEQual | GTHan | LTHan
*RST: EQ
TRIGger:
A:CAN:IDENtifier <Identifier>
Defines the identifier pattern. The pattern length is defined with TRIGger:A:CAN:
ITYPe on page 408.
The command is relevant if TRIGger:A:CAN:TYPE is set to ID or IDDT.
Parameters:
<Identifier> String containing binary pattern with max. 29 bit. Characters 0, 1,
and X are allowed.
TRIGger:A:CAN:DLC <DataLength>
Defines the length of the data pattern - the number of bytes in the pattern.
The command is relevant if TRIGger:A:CAN:TYPE is set to IDDT.
Parameters:
<DataLength> Range: 0 to 8
Increment: 1
*RST: 1
Default unit: Byte
TRIGger:A:CAN:DCONdition <DataCondition>
Sets the comparison condition for data: If the pattern contains at least one X (don't care),
you can trigger on values equal or not equal to the specified value. If the pattern contains
only 0 and 1, you can also trigger on a range greater than or lower than the specified
value.
The command is relevant if TRIGger:A:CAN:TYPE is set to IDDT.
Parameters:
<DataCondition> EQUal | NEQual | GTHan | LTHan
*RST: EQ
Command Reference
To Next Page
Loading...
