Rohde & Schwarz RTM2032 - Page 423

Remote Control
R&S
®
RTM20xx
408User Manual 1317.4726.02 ─ 01
Parameters:
<TriggerType> STOFrame | EOFrame | ID | IDDT | FTYPe | ERRCondition
STOFrame
Start of frame
EOFrame
End of frame
ID
Sets the trigger to a specific message identifier or an identifier
range.
Specify the identifier with TRIGger:A:CAN:ITYPe, TRIGger:
A:CAN:ICONdition, and TRIGger:A:CAN:IDENtifier.
IDDT
Sets the trigger to a combination of identifier and data condition.
The instrument triggers at the end of the last byte of the specified
data pattern.
Specify the identifier (see ID), and the data with TRIGger:A:
CAN:DLC, TRIGger:A:CAN:DCONdition, and TRIGger:A:
CAN:DATA.
FTYPe
Triggers on a specified frame type. Specify the frame type with 
TRIGger:A:CAN:FTYPe.
ERRCondition
Identifies various errors in the frame. Specify the errors with 
TRIGger:A:CAN:ACKerror, TRIGger:A:CAN:BITSterror,
TRIGger:A:CAN:CRCerror, and TRIGger:A:CAN:
FORMerror.
*RST:
STOF
TRIGger:A:CAN:FTYPe <FrameType>
Specifies the frame type to be triggered on if TRIGger:A:CAN:TYPE is set to FTYPe.
Parameters:
<FrameType> DATA | REMote | ERRor | OVERload | ANY
*RST: ERR
TRIGger:A:CAN:ITYPe <IdentifierType>
Selects the length of the identifier: 11 bit for CAN base frames, or 29 bits for CAN exten-
ded frames.
The command is relevant if TRIGger:A:CAN:TYPE is set to ID or IDDT.
Parameters:
<IdentifierType> B11 | B29 | ANY
ANY: only available for CAN trigger type IDDT
*RST: B11
Command Reference