Reference Waveforms
R&S
®
RTM20xx
77User Manual 1317.4726.02 ─ 01
If MSO option R&S RTM-B1 is installed, you can store also the pods of digital channels
as references.
Remote command:
REFCurve<m>:SOURce on page 322
REFCurve<m>:SOURce:CATalog? on page 323
Update
Stores the waveform defined as the "Source" to the selected reference waveform. The
reference waveform is kept until you update or load another waveform to the reference.
See also: chapter 5.1.1, "Displaying a Reference Waveform", on page 74.
Remote command:
REFCurve<m>:UPDate on page 323
Visible
Displays or hides the selected reference waveform.
Remote command:
REFCurve<m>:STATe on page 322
Save
Opens the "Save" menu with basic functions to save the equation set.
See "Save Menu" on page 220 .
Remote command:
REFCurve<m>:SAVE on page 323
Load
Provides functions to load reference data.
Reference ← Load
Selects one of the four possible internal reference storages.
See also: chapter 5.1, "Using References", on page 74.
Load ← Load
Opens the "Load" menu and a file explorer to select the reference waveform file for load-
ing.
See "Load Menu" on page 221.
Remote command:
REFCurve<m>:LOAD on page 324
Load Settings
Loads the device settings that were used to obtain the stored reference waveform. The
settings are only available if the file was stored to the internal storage /INT/
REFERENCE and never written to an external storage (USB stick).
Remote command:
REFCurve<m>:LOAD:STATe on page 324
Reference for REF key
To Next Page
Loading...
