Remote Control Commands
R&S
®
SMC100A
315Operating Manual 1411.4060.32 ─ 09
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
POW:EMF:STAT 1
activates voltage level display.
Manual operation: See " Display Level as Voltage of EMF - RF Level " on page 133
[:SOURce<hw>]:POWer[:LEVel][:IMMediate][:AMPLitude] <Amplitude>
Sets the RF level applied to the DUT.
Notes:
If specified, a level offset [:SOURce<hw>]:POWer[:LEVel][:IMMediate]:
OFFSet is included according to the formula:
Minimum level + OFFSet ... Maximum level + OFFSet
In addition to numerical values, you can increase or decrease the values step by step
with the UP and DOWN according to the step width defined with [:SOURce<hw>]:
POWer:STEP[:INCRement].
The RF output is activated with :OUTPut<hw>[:STATe] on page 267 (RF ON / RF
OFF).
Parameters:
<Amplitude> Minimum level ... Maximum level
Determines the RF output level.
Range: Minimum level to Maximum level
*RST: -30
Example: The keywords of this command are largely optional. Therefore,
both the long and short form of the command are shown.
SOUR:POW:LEV:IMM:AMPL 15
or
:POW 15
sets the RF level at output A to 15 dBm.
Manual operation: See " RF Level " on page 129
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:OFFSet <Offset>
Note: The level offset is also effective for level sweeps!
Specifies the constant level offset of a downstream attenuator/amplifier. If a level offset
is entered, the level entered with :POWer no longer corresponds to the RF output
level.
The following correlation applies:
POWer = RF output level + POWer:OFFSet.
SOURce Subsystem
To Next Page
Loading...
