Rohde & Schwarz SMC100A - Page 340

Remote Control Commands
R&S
®
SMC100A
325Operating Manual 1411.4060.32 ─ 09
SOURCe:PULM:TRAin:SEL ‘P_FIVE'
// Enter the pulse train data
SOURCe:PULM:TRAin:ONTime 10ns,30ns,40ns,20ns,10ns
SOURCe:PULM:TRAin:OFFTime 30ns,40ns,50ns,40ns,30ns
SOURCe:PULM:TRAin:REPetition 10,1,3,10,6
// ******************************************************************
// Select pulse train mode
// ******************************************************************
// Select the internal modulation generator and the pulse mode
SOURce:PULM:SOURce INTernal
SOURce:PULM:MODE PTRain
// ******************************************************************
// Activate the signal output
// ******************************************************************
SOURce:PGENerator:OUTPut:STATe 1
SOURce:PULM:STATe 1
OUTPut1:STATe 1
[:SOURce<hw>]:PULM:DELay........................................................................................ 325
[:SOURce<hw>]:PULM:DOUBle:DELay............................................................................326
[:SOURce<hw>]:PULM:DOUBle:STATe........................................................................... 326
[:SOURce<hw>]:PULM:DOUBle:WIDTh........................................................................... 326
[:SOURce<hw>]:PULM:MODE........................................................................................ 326
[:SOURce<hw>]:PULM:PERiod....................................................................................... 327
[:SOURce<hw>]:PULM:POLarity..................................................................................... 327
[:SOURce<hw>]:PULM:SOURce..................................................................................... 328
[:SOURce<hw>]:PULM:STATe........................................................................................328
[:SOURce<hw>]:PULM:TRIGger:EXTernal:GATE:POLarity................................................ 328
[:SOURce<hw>]:PULM:TRIGger:EXTernal:SLOPe............................................................329
[:SOURce<hw>]:PULM:TRIGger:MODE........................................................................... 329
[:SOURce<hw>]:PULM:WIDTh........................................................................................329
[:SOURce<hw>]:PULM:DELay <Delay>
Sets the pulse delay.
Note: Pulse delay is adjustable for external trigger modes.
Parameters:
<Delay> float
Range: 100 ns to 1 s
Increment: 100 ns
*RST: 100 ns
Example:
PULM:DEL 13 us
13 us elapse after a trigger before the first pulse is generated.
Manual operation: See " Pulse Delay - Pulse Generator " on page 188
SOURce Subsystem