In the next step you are prompted to select the
printer model from the list. Here too, the available
selection is dependant upon the existing license
options.
Press "Next" afterwards.
Figure 6.7: Selection of printer model
After having selected the printer model, you have to
indicate how to access your printer in the network.
For this purpose, enter the IP address of the printer
or its host name in the text field.
Should you have problems regarding the
availability of the printer in the network,
check the network settings of your
computer and the printer.
Figure 6.8: Printer IP / host name
Enter any designation for the printer to be set up in
the following text field. ScanManager then identifies
the printer on the basis of this name (see printer
selection, Chapter 5.11.2.1 ).
If the printer just added is a color printer, you are
asked whether you want to perform a color
calibration. If yes, click Start Profiling. For the
further steps, please refer to Chapter 6.5.3 as from
Figure 6.12.
If you do not want to effect color profiling, click
"Skip" whereby the printer installation is completed.
You can also perform the color calibration of the
printer later.
If the added printer is not a color printer, the
installation has now been completed successfully.
6.5.2 Deleting Printer
If you want to remove a printer already
installed, select „Delete printer“ under
"Printer". Afterwards, you are prompted to
select the printer to be deleted. The list
shows all printers already installed. After
having selected the printer to be deleted,
click "Next" and confirm the safety query.
Figure 6.10: Printer selection
6.5.3 Creating a Printer Profile
The color reproduction quality on color printers can be optimized by so-called ICC color
profiles. This optimization is necessary because each printer shows colors differently.
To Next Page
Loading...
