Managing the Access Point
Enabling Other Management Access Options
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 169
3 If you want to use TR-069 or SNMP to manage the AP, configure the settings
listed in Tab l e 5 9.
Telnet Port This field lists the default Telnet port of 23 — only if Telnet is active.
You can manually change this port number, if required.
SSH Access By default, this option is enabled (active).
SSH Port This field lists the default SSH port of 22—only if SSH is active. You
can manually change this port number if required.
HTTP Access This option is disabled by default.
HTTP Port This field lists the default HTTP port of 80, if HTTP has been
activated. You can manually change this port number if required.
HTTPS Access By default this option is enabled. This connection mode requires a
security certificate, a copy of which has been pre-installed in the
device.
HTTPS Port This field lists the default HTTPS port of 443—only if HTTPS has
been activated. You can manually change this port number if
required.
Certification
Verification
This notes whether the security certificate linked to the HTTPS
settings has been passed or not.
Auto-provisioning This setting is disabled by default, and should only be enabled if
using FlexMaster server for AP management.
Table 59. TR-069 and SNMP Management Options
Option Description
Auto Enables the ZoneFlex device to be managed by either
SNMP server, Ruckus Wireless ZoneDirector, or Ruckus
Wireless FlexMaster.
SNMP only Only allow SNMP management.
FlexMaster only Only allow FlexMaster management.
DHCP Discovery URL of server providing DHCP.
FlexMaster Server URL URL of the FlexMaster server.
Table 58. Management Access Options (Continued)
Option Description
To Next Page
Loading...
