Configuration Guide Configuring Syslog
Run the show logging config command to display the configuration.
Ruijie#show logging config
Syslog logging: enabled
Console logging: level informational, 1304 messages logged
Monitor logging: level informational, 0 messages logged
Buffer logging: level debugging, 1304 messages logged
File logging: level informational, 119 messages logged
File name:syslog_test.txt, size 128 Kbytes, have written 5 files
Standard format:false
Timestamp debug messages: datetime
Timestamp log messages: datetime
Sequence-number log messages: enable
Sysname log messages: enable
Count log messages: enable
Trap logging: level informational, 119 message lines logged,0 fail
Common Errors
To disable this function, run the terminal no monitor command, instead of the no terminal monitor command.
7.4.4 Writing Syslogs into the Memory Buffer
Configuration Effect
Write syslogs into the memory buffer so that the administrator can view recent syslogs by running the show logging
command.
Notes
If the buffer is full, old logs will be overwritten by new logs that are written into the memory buffer.
Configuration Steps
Writing Logs into the Memory Buffer
(Optional) By default, the system writes logs into the memory buffer, and the default level of logs is debugging (Level 7).
Unless otherwise specified, perform this configuration on the device to write logs into the memory buffer.
Verification
Run the show logging config command to display the level of logs written into the memory buffer.
To Next Page
Loading...
Need help?
General
