Ruijie RG-WLAN Series

Configuration Guide Configuring RSNA
Ruijie(config-wlansec)#security rsn ciphers aes enable
Ruijie(config-wlansec)#security rsn akm psk enable
Ruijie(config-wlansec)#security rsn akm psk set-key ascii 12345678
Ruijie(config-wlansec)#authtimeout paircount 5
Ruijie(config-wlansec)#webauth
Ruijie(config-wlansec)#webauth prevent-jitter 900
Verification
Run the show running-config | begin wlansec wlan_id command to check whether the configuration takes
effect.
AP
Ruijie#show running-config | begin wlansec 1
wlansec 1
security rsn enable
security rsn ciphers aes enable
security rsn akm psk enable
security rsn akm psk set-key ascii 12345678
webauth prevent-jitter 900
webauth
authtimeout paircount 5
Common Errors
 The jitter prevention time of WEB authentication is configured before WEB authentication is enabled.
1.5 Monitoring
Displaying
Description
Command
Displays security configuration of a WLAN.
show wlan security wlan-id
Displays security configuration of an STA.
show wclient security mac-address