Ruijie RG-WLAN Series

Configuration Guide Configuring FAT APs
Scenario
Figure 1-8
Assuming that in a FAT AP environment, an AP operating in the e-bag scenario is required to be configured
with e-bag network optimization by using the one-key mode.
Configuration
Steps
 configure e-bag parameters on an AP:
FAT AP
Ruijie# configure terminal
Ruijie(config)# ebag
Verification
 Run the show running-config command to check the e-bag parameter settings on a specified AP.
Ruijie(config)# show running-config
!
eth-schd 25
!
interface Dot11radio 1/0
ampdu-retries 2
no ampdu-rts
!
interface Dot11radio 2/0
ampdu-retries 2
no ampdu-rts
!
Common Errors
 N/A.
1.4.5 Configuring the Link Integrity Check Function
Configuration Effect