Ruijie RG-WLAN Series

Configuration Guide Configuring FAT APs
 Enable the link integrity check function.
Notes
 N/A
Configuration Steps
 Enabling the Link Integrity Check Function
 (Mandatory) Run the link-check enable command to enable the link integrity check function.
Command
link-check enable
Parameter
Description
-
Command
Mode
Global configuration mode
Usage Guide
The link integrity check function is disabled by default.
Verification
 Run the show running-config command to check the link integrity check function.
Configuration Example
 Configuring the Link Integrity Check Function
Scenario
Figure 1-9
FAT APIf the link integrity check function needs to be enabled in a FAT AP environment as shown in Figure
1-9, then:
1. Enable the link integrity check function.
Configuration
Steps
 Configure the link integrity check function on the AP equipment.