Configuration Guide Configuring Syslog
Notes
Periodical logging takes effect only when the RFC5424 format is enabled.
The settings of the periodical logging interval and the function of displaying logs on the Console and remote terminal
take effect only when the periodical logging function is enabled.
It is recommended to disable periodical display of logs on the Console and remote terminal. Otherwise, a large amount
of performance statistic logs will be displayed, increasing the burden on the device.
To ensure the server can collect all performance statistic logs at the same time point, the timer will be restarted when
you modify the periodical logging interval of a statistic object.
Configuration Steps
Enabling Periodical Logging
(Optional) By default, periodical logging is disabled.
Unless otherwise specified, perform this configuration on the device to enable periodical logging.
Enabling Periodical Display of Logs on Console and Remote Terminal
(Optional) By default, periodical display of logs on the Console and remote terminal is disabled.
Unless otherwise specified, perform this configuration on the device to enable periodical display of logs on the Console
and remote terminal.
Configuring the Periodical Logging Interval
(Optional) By default, the periodical logging interval is 15 minutes.
Unless otherwise specified, perform this configuration on the device to configure the interval at which logs of statistic
objects are sent to the server.
Verification
Run the show running command to display the configuration.
Related Commands
Enabling Periodical Logging
Global configuration mode
This command is used to enable periodical logging. After this function is enabled, the system outputs a
series of performance statistics at a certain interval so that the log server can monitor the system
performance.
To Next Page
Loading...
Need help?
General
