Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring FAT APs
Description
Defaults
The transmit power for management frames is 0, which indicates that no transmit power is configured for
management frames.
Command
Mode
dot11radio interface configuration mode
Usage Guide
-
 Configuring the STA Idle Time
 Optional.
 If there are no special requirementsIf there are no special requirements, you can perform this configuration in the
dot11radio interface configuration mode of the AP equipment.
 The shorter the STA idle time, the easier STAs leave a WLAN due to lower traffic.
Command
sta-idle-timeout seconds
Parameter
Description
seconds: indicates the STA idle time, ranging from 60 to 86400 seconds.
Defaults
The STA idle time is 300 seconds.
Command
Mode
dot11radio interface configuration mode
Usage Guide
-
 Configuring Channels
 (Optional) Run the channel command to configure channels.
 If there are no special requirements, you can perform this configuration in the dot11radio interface configuration mode
of the AP equipment.
 At the 2.4 GHz band, overlapped channels may cause interference for each other. To avoid conflict of wireless signals,
it is recommended that non-overlapped channels (such as channels 1, 6, and 11) be configured. At the 5 GHz band, the
24 channels (channels 36, 40, 44, 48, 52, 56, 60, 64, 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140, 149, 153,
157, 161 and 165) are not overlapped and do not cause interference for each other.
Command
channel channel-num
Parameter
Description
channel-num: indicates a working channel.
Defaults
Channel 1 is used at the 2.4 GHz band and channel 149 is used at the 5.8 GHz band.
Command
Mode
dot11radio interface configuration mode
Usage Guide
-
 Configuring the Fragment Threshold
 (Optional) Run the fragment-threshold command to configure the fragment threshold, which must be an even number.

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English