Ruijie RG-WLAN Series - Page 258

Configuration Guide Configuring Interfaces
No IPv6 address
MTU 1500 bytes, BW 2000 Kbit
Encapsulation protocol is frame-relay, loopback not set
Keepalive interval is 10 sec , set
Carrier delay is 2 sec
Queueing strategy: WFQ
Rxload is 1/255,Txload is 1/255
5 minutes input rate 0 bits/sec, 0 packets/sec
5 minutes output rate 0 bits/sec, 0 packets/sec
235 packets input, 434532 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 abort
35 packets output, 36545 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
Router B
RB# show interfaces gigabitEthernet 0/1.1
Index(dec):10 (hex):10
GigabitEthernet 0/1 is UP , line protocol is UP
Hardware is OCTEON-SGMII GigabitEthernet, address is 00d0.f8fb.5946 (bia 00d0.f8fb.5946)
Interface address is: 192.168.2.1/24
ARP type: ARPA,ARP Timeout: 3600 seconds
Interface IPv6 address is:
No IPv6 address
MTU 1500 bytes, BW 1000000 Kbit
Encapsulation protocol is 802.1Q Virtual LAN,Vlan ID 2
RB# show interface serial 1/0
Index(dec):1 (hex):1
Serial 1/0 is UP , line protocol is UP
Hardware is Infineon DSCC4 PEB20534 H-10 serial
Interface address is: 172.16.1.1/24
Interface IPv6 address is:
No IPv6 address