Ruijie RG-WLAN Series - Page 31

Configuration Guide Configuring RF Scheduling
When the scheduling session starts or ends, the system sends a scheduling message. In the handling of the scheduling
message, the processing logic will locate the WLAN where this scheduling session is applied to, and enable or disable the
WLAN.
 Applying a Scheduling Session on an RF Interface
After the scheduling session is created, it must be applied to the corresponding WLAN so that the scheduling can take
effect.
You need to specify in WLAN configuration mode the scheduling Session ID for the WLAN.
 Handling of a Scheduling Message
After a scheduling session is created and the cycle and interval are specified, the system will start the timer of the
scheduling session, and send a message after entering or exiting from this scheduling session. A scheduling message
includes the following information:
 Scheduling Session ID
 Message type: entering or exiting from the scheduling session
The handling of a scheduling message covers all WLANs. The system will first check the session to which the WLAN is
applied. If the scheduling Session ID to which the WLAN is applied is the same as that in the message, the message type
will be checked. If in the scheduling state, the WLAN will be disabled. Otherwise, the radio will be enabled.
1.4 Configuration
Configuration
Description and Command
Configuring AP RF
Scheduling
(Mandatory) It is used to create a scheduling session, specify the time interval, and
apply the scheduling session to an AP or AP group.
schedule session
Creates a scheduling session.
schedule session time-range
Specifies the time interval of a scheduling
session.
schedule session
Applies the scheduling session to a
wireless interface.
Configuring WLAN
Scheduling
(Mandatory) It is used to create a scheduling session and apply it to a WLAN.
schedule session
Creates a scheduling session.
schedule session time-range
Specifies the time interval of a scheduling
session.
schedule session
Applies the scheduling session to a WLAN.
1.4.1 Configuring AP RF Scheduling
Configuration Effect
 Create a scheduling session, specify a scheduling interval, and applies this scheduling session to a wireless
interface to realize AP RF scheduling.