Ruijie RG-WLAN Series - Page 33

Configuration Guide Configuring RF Scheduling

Command
schedule session sid
Parameter
Description
sid: Indicates Session ID. It can be set to a value ranging from 1 to 8 on a fat AP.
Defaults
No scheduling session is applied.
Command
Mode
WLAN configuration mode or interface configuration mode
Usage Guide
N/A
Verification
 Run show running-config to display configurations on RF scheduling.
 Check whether scheduling is still performed for AP RF after a scheduling session expires.
Configuration
Example
N/A
Common Errors
 No scheduling session is created.
 The interval of the scheduling session is not properly configured.
 The scheduling priorities on the AP are in conflict.
 Scheduling is not applied to the target radio.
1.4.2 Configuring WLAN Scheduling
Configuration Effect
 Create a scheduling session, specify a scheduling interval, and apply this scheduling session to a WLAN to realize
WLAN scheduling.
Configuration Steps
 Creating a Scheduling Session
 (Mandatory) Run the schedule session sid command to specify the scheduling Session ID of a WLAN.
 After a scheduling session is applied, if the message for the scheduling session is displayed, the specified WLAN
interface will automatically enter or exit from the scheduling state as specified by the massage type.
Command
schedule session sid
Parameter
Description
session sid: Indicates Session ID. It can be set to a value ranging from 1 to 8 on a fat AP.
Defaults
No scheduling session is applied on a WLAN.
Command
Mode
Global configuration mode
Usage Guide
N/A