Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring NAT
 Unless otherwise noted, the interface connecting intranet should be configured as the NAT inside interface.
 Configuring the NAT Outside Interface
 Mandatory configuration.
 Unless otherwise noted, the interface connecting extranet should be configured as the NAT outside interface.
 Configuring Static Translation of Outside Source Address
 Optional configuration.
 Configure static translation of outside source address in global configuration mode when a small number of users in
the extranet need to access the intranet.
 Configuring Dynamic Translation of Outside Source Address
 Optional configuration.
 Configure dynamic translation of outside source address in global configuration mode when a large number of users
in the extranet need to access the intranet.
 Configuring an ACL
 ACL configuration is mandatory when dynamic source address mapping is used.
 Restrict the range of users requiring source address translation in the intranet.
 Configuring a Static Route
 Mandatory configuration.
 Specify the network egress after inside destination address translation.
Verification
N/A
Commands
 Configuring the NAT Inside Interface and the NAT Outside Interface
Command
Syntax
ip nat { inside | outside }
Parameter
Description
inside: inside interface
outside: outside interface
Command
Mode
Interface configuration mode
Configuration
Usage
NAT does not work on a data packet unless a route exists between the outside interface and the inside
interface and the data packet meets a certain rule. Therefore, at least one inside interface and one
outside interface need to be configured on the router.
 Configuring Static Translation of Outside Source Address
Command
ip nat outside source static global-address local-address

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English