Configuration Guide Configuring Web Authentication
After Web authentication is enabled, the unauthenticated clients connecting to a port will be redirected to the Webauth URL.
 Enabling AAA
By default, AAA is disabled.
Run the aaa new-model command in global configuration mode to enable AAA.
Ruijie Second-Generation Web Authentication relies on AAA. Enable AAA before you implement the former.
 Configuring the RADIUS-Server Host and Communication Key
By default, the RADIUS-server host and communication key are not configured.
Run the radius-server host command in global configuration mode to configure the RADIUS-server host and
communication key.
The RADIUS-server host is responsible for authenticating users.
 Configuring an AAA Method List for Ruijie Second-Generation Web Authentication
By default, no AAA method list is configured for Ruijie Second-Generation Web Authentication.
Run the aaa authentication web-auth command in global configuration mode to configure an AAA method list for Ruijie
Second-Generation Web Authentication.
The AAA authentication method list is used for interaction during the Webauth process.
 Configuring an AAA Method List for Ruijie Second-Generation Web Accounting
By default, no AAA method list is configured for Ruijie Second-Generation Web Accounting.
Run the aaa accounting network command in global configuration mode to configure an AAA method list for Ruijie
Second-Generation Web Accounting.
The AAA method list for Web accounting is used for accounting interaction during the Webauth process.
 Specifying an AAA Method List
The default AAA method list is used if no list is specified.
Run the authentication command in template configuration mode to specify an AAA method list.
The AAA method list is specified to send authentication requests to AAA.
 Specifying an AAA Accounting Method List
The default AAA accounting method list is used if no list is specified.
Run the accounting command in template configuration mode to specify an AAA accounting method list.
The AAA accounting method list is specified to send accounting requests to AAA.
 Specifying the UDP Port of the Portal Server
By default, UDP Port 50100 is used.
To Next Page
Loading...
Need help?
General
