Configuration Guide Configuring AAA
list-name: Indicates the name of a network accounting method list in characters.
start-stop: Indicates that a start-accounting message and a stop-accounting message are sent when a user
accesses a network and when the user disconnects from the network respectively. The start-accounting
message indicates that the user is allowed to access the network, regardless of whether accounting is
successfully enabled.
method: Indicates authentication methods from none and group. A method list contains up to four methods.
none: Indicates that network accounting is not performed.
group: Indicates that a server group is used for network accounting. Currently, the RADIUS and TACACS+
server groups are supported.
Global configuration mode
The RGOS sends record attributes to the security server to perform accounting of user activities. The
start-stop keyword is used to configure user accounting options.
 Enabling Accounting Update
Global configuration mode
Accounting update cannot be used if the AAA services are not enabled. After the AAA services are enabled,
run this command to enable accounting update.
 Configuring the Accounting Update Interval
aaa accounting update periodic interval
Interval: Indicates the accounting update interval, in the unit of minutes. The shortest is 1 minute.
Global configuration mode
Accounting update cannot be used if the AAA services are not enabled. After the AAA services are enabled,
run this command to configure the accounting update interval.
Configuration Example
 Configuring AAA EXEC Accounting
Configure login authentication and EXEC accounting for users on VTY lines 0 to 4. Login authentication is performed in local
mode, and EXEC accounting is performed on a RADIUS server.
To Next Page
Loading...
Need help?
General
