Ruijie RG-WLAN Series

Configuration Guide Configuring IGMP Snooping
Mode
Usage Guide
A querier can be run in IGMPv1 and IGMPv2 (IGMPv2 by default). You can also run a command to
configure the version to IGMPv1.
If the IGMP version for a querier is specified by a VLAN, the version will be used preferentially.
 Displaying the IGMP Querier Configuration
Command
show ip igmp snooping querier detail
Parameter
Description
N/A
Command
Mode
Privileged EXEC mode, global configuration mode, or interface configuration mode
Usage Guide
If QinQ is enabled, the following content is displayed.
Ruijie(config)#show ip igmp snooping querier detail
Vlan IP Address IGMP Version Port
-----------------------------------------------------------
Global IGMP switch querier status
--------------------------------------------------------
admin state : Enable
admin version : 2
source IP address : 1.1.1.1
query-interval (sec) : 60
max-response-time (sec) : 10
querier-timeout (sec) : 125
Vlan 1: IGMP switch querier status
--------------------------------------------------------
admin state : Disable
admin version : 2
source IP address : 1.1.1.1
query-interval (sec) : 60
max-response-time (sec) : 10
querier-timeout (sec) : 125
operational state : Disable
operational version : 2
Configuration Example
 Enabling the IGMP Querier Function