Sartorius Cubis MCA2.7S - Accessories; Printers and Communication

Operating Instructions Cubis
®
MCA 103
Accessories
16 Accessories
16.1 Accessories
This table contains an excerpt of the accessories that can be ordered.
Forinformation on other products, contact Sartorius.
16.1.1 Printers and Communication
Item Quantity Order number
Thermal transfer | thermal printer for
GLP | GMP printouts on continuous paper
and labels
1 YDP30
Thermal transfer | thermal network printer
with Ethernet connection for GLP | GMP
printouts on continuous paper and labels
1 YDP30-NET
Wireless nano USB adapter for company
network or independent Wi-Fi network,
e.g.,operation with a Sartorius network
printer YDP30-NET (only for Europe)
1 YWLAN01MS
Wireless nano router, e.g., for Sartorius
network printer YDP30-NET for operation
inan independent Wi-Fi network
(onlyforEurope)
1 YWLAN02MS
Display cable, 3 m, for separate installation
of display and weighing units, installation
bySartorius Service or at the factory
1 VF4754
Installation of display cable, 3 m, for
separate installation of display and
weighingunits
1 VF4016
Cable, 3 m, between the weighing module
and electronics module for
semi-microbalance
1 YCC01-MSM3
RS232C connection cable, 9-pin, 3 m,
forconnection to a PC with 9-pin
COMinterface
1 VF4761
USB QR barcode scanner 1 YRB05
Sartorius Wedge, software for data
communication between the PC and device
1 YSW02
Foot switch for the draft shield “Open/
closed” functions (only in combination with
motorized draft shield), taring and printing
1 YFS02