Sartorius Cubis MCA2.7S - Connecting the Power Supply; Attaching the Protective Caps

Operating Instructions Cubis
®
MCA 49
Getting Started
6.2 Connecting the Power Supply
Procedure
t
WARNING Severe injuries caused by using a defective power supply
cable! Check the power supply cable for damage, e.g., cracks in the
insulation.
t If required: Contact Sartorius Service.
t Check whether the country-specific power plug matches the power
connections at the installation site.
t If required: Contact Sartorius Service.
t NOTICE Damage to the device due to excessive input voltage!
Checkwhether the voltage specifications on the AC adapter match
those of the power supply at the installation site.
t If the input voltage is too high: Do not connect the device to
thepower supply.
t Contact Sartorius Service.
t Connect the mains plug of the power supply cable to the wall outlet
atthe installation site.
y The [Booting device...] display appears in the operating display.
y The [Starting system...] display appears in the operating display.
y The [Starting application...] display appears in the operating display.
y The [Loading] display appears in the operating display.
y The device performs an initial tare function.
6.3 Attaching the Protective Caps
If connections of the device are not being used during operation:
Theconnections must be sealed with the protective caps supplied.
Procedure
t Check whether all unused connections have been sealed with
aprotective cap.
t Place the protective caps (1) for the electrical connections on the
unusedconnections.
1