Sartorius Cubis MCA2.7S - System Settings; Performing System Settings; Switching off the Isocal Function

50 Operating Instructions Cubis
®
MCA
System Settings
7 System Settings
7.1 Performing System Settings
Default settings can be adjusted for the device and the applications in order
to align with the ambient conditions and individual operating requirements.
The following settings are necessary to operate the device together with
connected components:
− Set up the communication of the connected devices
− Set up additional components
The following settings are recommended to set up the device:
− Set the menu language
− Select date | time format
− Setting the date, time, and time zone
− Assigning a password
− Set the behavior of the isoCAL function
− Set the behavior of the motorized draft shield (only for devices with
amotorized draft shield)
Procedure
t Open the main menu.
t Press the [Setup] button.
t To adjust settings: Open the desired submenu.
t Select the desired configuration value (see Chapter“7.7 Parameter List”,
page 55).
t Exit the menu.
7.2 Switching Off the isoCAL Function
If the isoCAL function is switched off for a conformity-assessed device:
Thedevice can only be used for legal-for-trade applications in restricted
temperature ranges (see Chapter“15.3.2 Ambient Temperature for the
isoCAL Function”, page 99). TheisoCAL function cannot be switched
off for all model versions.
Procedure
t In the “Settings / Device Settings / Safe Weighing / isoCAL Execution
Mode” menu, for the “isoCAL function” parameter, select the
“Off”configuration value.