Sartorius Cubis MCA2.7S - Decommissioning; Decommissioning the Device; Transport; Transporting the Device

94 Operating Instructions Cubis
®
MCA
Decommissioning
11 Decommissioning
11.1 Decommissioning the Device
Procedure
t Turn the device off.
t Disconnect the device from the power supply.
t Disconnect the device from all connected devices and all accessories,
e.g. printer or electronics module.
t Clean the device (see Chapter 9.2, page 89).
t If below-balance weighing has been set up:
t Turn the device on its side and place it on a soft support base.
t Insert cover plate (1) and screw on with both screws (2).
t Place the device back on the device base on a level surface.
12 Transport
12.1 Transporting the Device
Procedure
t
CAUTION Risk of injury from breaking glass Glass components
canbreak if they fall or are handled incorrectly. Glass fragments can
causecuts.
t Only lift the device by its base, not by the draft shield.
t When lifting and transporting, ensure that no personnel or objects are
inthe way.
t Get help from additional persons when lifting and transporting
thedevice.
t Use suitable conveyance devices, e.g. trolleys, for long transport routes.
2
1