Sartorius Cubis MCA2.7S - Motorized Draft Shield; Sensor Area; Operating Elements; For the Draft Shield

Operating Instructions Cubis
®
MCA 17
Device Description
3.9 Motorized Draft Shield
3.9.1 Sensor Area
The device has a motion sensor that opens the draft shield automatically
assoon as a motion is detected within the sensor area. Following that the
draft shield will be automatically closed again. The operation is optimized
forleft- and right-handed users due to the motion sensor.
The motion sensor has a right and a left sensor window.
The motion sensor has two modes:
− Proximity sensor (one-hand operation)
− Crossover method (two-hand operation)
The motion sensor sensitivity can be adjusted in steps (see Chapter “7.7.26
Parameters in the “Device Settings / Draft Shield” Menu
(OnlyforDeviceswithaMotorizedDraft Shield)”, page 73).
3.9.2 Operating Elements for the Draft Shield
The draft shield can be opened and closed via the palm-operated key.
Operation via the palm-operated key enables the opening and closing
ofthe draft shield as well as the activation and deactivation of the
motionsensor.
3.10 Conformity-assessed Devices
Some settings of conformity-assessed models are protected against user
changes, e.g. “external calibration” for devices in accuracy class II.
Thismeasure is intended to ensure the suitability of the devices for use
inlegal metrology.