Sartorius Cubis MCA2.7S - Storage and Shipping; Storage; Returning Device and Parts

Operating Instructions Cubis
®
MCA 95
Storage and Shipping
13 Storage and Shipping
13.1 Storage
Procedure
t Turn the device off.
t Disconnect the device from the power supply.
t Disconnect the device from all connected devices and all accessories,
e.g. printer.
t Clean the device (see Chapter 9.2, page 89).
t Store the device according to the ambient conditions
(see Chapter “15.7 Metrological Data”, page 100).
13.2 Returning Device and Parts
Defective devices or device components can be returned to Sartorius.
Returned devices must be clean, decontaminated, and properly packed,
e.g.in the original packaging.
Transport damage as well as measures for subsequent cleaning and
disinfection of the device or device components by Sartorius shall
becharged to the sender.
WARNING
Risk of injury due to contaminated devices!
Devices contaminated with hazardous materials (NBC contamination)
willnot be accepted for repair or disposal.
t Observe the information on decontamination (see Chapter 14.1,
page 96).
Procedure
t Switch off the device.
t Disconnect the device from the power supply.
t Disconnect the device from all connected devices and all accessories,
e.g. printer.
t Clean the device.
t Contact Sartorius Service for instructions on how to return devices
ordevice components (please refer to www.sartorius.com for return
instructions).
t Pack the device and the device components properly for return,
e.g.inthe original packaging.