Sartorius Cubis MCA2.7S - Configuring Print Profiles; Descriptions of Interface Protocols; And Website Certificates

54 Operating Instructions Cubis
®
MCA
System Settings
7.5.3 Configuring Print Profiles
Procedure
t Open the “Settings / Weighing and Print Profile / YDP30” menu.
t Edit a pre-configured print profile or create a new print profile by
pressing the [New] button, e.g., network printer YDP30-NET.
t Follow the wizard’s instructions in the operating display for more
settings.
t Confirm the entries. In order to do so, press the [OK] button.
t Add the created print profile to a task (see Chapter“8.6 Adding
Weighing and Print Profiles to a Task”, page 81).
7.6 Descriptions of Interface Protocols
andWebsite Certificates
The descriptions of the following interface protocols are available as PDF
files in English and German:
− SBI protocol
− SICS protocol
− miniSICS protocol
A description on installation for a website certificate is available as a PDF file
in English entitled “Installation Instructions for Website Certificate”.
These PDF files are available to download under “Cubis
®
II MCA Firmware”
via the Sartorius website www.sartorius.com.