Sartorius Cubis MCA2.7S - Adding an Application to a Task; Adding Weighing and Print Profiles to a Task; Preparing Weighings

Operating Instructions Cubis
®
MCA 81
Operation
8.5.2 Adding an Application to a Task
Applications must be added to a task so that they can run.
Procedure
t Open Task Management.
t Press the [New] button.
y A list of all activated applications is displayed.
t To select an application: Press the desired application.
y The wizard for creating a new task starts.
t Follow the wizard’s instructions in the operating display.
8.6 Adding Weighing and Print Profiles to a Task
To be able to use a weighing or print profile: Add a weighing or print profile
to a task. Weighing and print profiles can be configured in the
Settingsmenu.
Procedure
t Open the task.
t Create or edit a task. In order to do so, start the wizard to create or edit
atask and follow the wizard’s instructions in the operating display.
8.7 Preparing Weighings
The device must be prepared before every weighing.
Procedure
t Level the device.
t Zero the device. In order to do so, press the [Zero] button.
t If the device cannot be zeroed: Remove the sample to be weighed
andre-zero the device.
t Calibrate the device.