Sartorius Cubis MCA2.7S - Parameters in the Connections; Climate Modules Menu

68 Operating Instructions Cubis
®
MCA
System Settings
Parameter Setting Values Explanation
Automatic output Off* Deactivates the automatic data output. The data output must
betriggered by means of an SBI command with “ESC P”.
Each weight value Starts the automatic data output with each value according to
thedisplay result.
1 second Starts the automatic data output every second.
2 seconds Starts the automatic data output every 2seconds.
5seconds Starts the automatic data output every 5seconds.
10seconds Starts the automatic data output every 10seconds.
30seconds Starts the automatic data output every 30seconds.
60seconds Starts the automatic data output every 60seconds.
Display SBI error
messages
Off* Displays no error messages.
On Displays error messages if errors occur when receiving
andexecuting SBI commands.
Formatting output
values
Output in one line with
full length
− Outputs the elements in the full length, e.g., header and value.
− The elements are separated by a space character, left-aligned,
and output without infilling with space characters.
Output in several lines
with 20 char. each
− Distributes outputs, which due to their length do not fit in the
standard output format of 20 characters, over several lines with
20 characters each.
− Aligns each line to the left and infills with space characters
tomake up 20 characters.
Cut off to a 20
character line*
− Defines the output in a standard output format
of20characters.
− Crops the end of longer outputs.
* Factory setting
7.7.15 Parameters in the “Connections / Climate Modules” Menu
Parameter Setting Values Explanation
Climate modules Display of connected
climate module
Activates climate modules if they are connected to the device.