[Function]
Set the character barcode height of the first and the last digit to the same height of the guard bar.
[Format 1]
<BM>abbcccn~n
●Parameter
a
[barcode type] = H : UPC-A( fixed 'H')
b
[Narrow bar] = Valid Range : 01 to 12 dots
c
[Height of Barcode] = Valid Range : 001 to 999 dots
n
[Print data] = Data : fixed 11 dight
[Coding Example]
Barcode type:UPC-A, Narrow bar width:02, Barcode height :120, Print data: 20123948573
<A>
<H>100<V>100<BM>H0212020123948573
<Q>2
<Z>
[Supplementary Explanation]
1. This command supports UPC-A only. When barcode type is specified other than “H”, command error occurs.
2. HRI needs following conditions;
8dot /mm(203dpi) : Set Narrow bar width to [02] or [03]
12dot/mm(305dpi) : Set Narrow bar width to [03] or [04]
When the value other tham above are specified, HRI is not printed.
3. Setting of Guard bar, HRI and Ratio is following.
4. When the parameter value exceeds the range, operation is not supported.
5. All character barcode have the same height when printing UPC-A specifying <D> and then <font>. The first and the last
character barcode have the same height to the guard bar when printing UPC-A specifying <BL> and then <font>.
When printing UPC-A specifying <D> and <font>, HRI can be printed under the first digit and the last digit because the height of the
first digit and the last digit of the barcode is low. When printing UPC-A specifying <BL> and <font>, the height of the first digit
and the last digit of the barcode is high, and the font interval is narrower than previous case.
UPC-A specifying <BD> UPC-A specifying <BM>
UPC-A Barcode (With HRI)
To Next Page
Loading...
