[Function]
Specifying QR Code (Micro QR Code)
[Format] (Setup part)
<2D32>,a,bb,c
●Parameter
a
[Error Correction Level] = L : 7%
M : 15%
Q : 25%
b [Size of one side of cell] = Valid Range : 01 to 32 dots
* Recommend to specify more than 2 dots in the 8 dots/mm and 12 dots/mm for scanner readability.
c [Data setup mode = 0 : Manual setup
1 : Automatic setup
[Format] (Dat part)
Manual setup (Data setup mod)
<DS>k,n~n
* Use when input mode specification is Numeric mode, Alphanumeric mode and Kanji mode.
<DN>mmmm, n~n * Use when specifying by binary.
Automatic setup (Data setup mode)
<DN>mmmm, n~n * Change input mode automatically according to input data.
●Parameter
k [Input mode] = 1 : Numeric mode
2 : Alphanumeric mode
3 : Kanji mode (Shift JIS Kanji)
* There is binary specification other than above, but data specification command is different.
m [Number of data] = Valid Range : 1 to 15
* Specify when specifying Automatic setup in Data setting mode.
n [Print data] = Data
[Supplementary Explanation1]
1. When specifying Kanji in <DN>, specify size that is 2 X number of Kanji characters.
2. For <DN> in Automatic setup, when 80H to 9FH and E0H to FFH is specified as data, it is handed as Kanji mode, and cannot
specify them as binary.
3. Set by manual setting when mixing binary, alphanumeric and kanji. You cannot set it by Auto settings.
[Coding Example1] Error correction level :7%, Size of one side of cell:04
<A>
<V>100<H>200<2D32>,L,04,0
<DS>1,012345
<Q>2
<Z>
[Supplementary Explanation2]
1. If the parameter other than the description is specified or number of print data is not match, print is not executed.
2. Data specification command in data part varies according to parameter setup or specified data.
Micro QR Code
To Next Page
Loading...
