SATO CL408e - Removing a Printer

17
5.5 Control
Printer
CL408e/412e
M-8400RVe
CL608e/612e
M-5900RVe
M-10e
M-8485Se/90Se/60Se/59Se M-84Pro-2/3/6 LC408e/412e
5.5 ESC+WK Job Name
ESC+WK
HEX Code
ESC
WK
Parameter
<1B>16
<57>16<4B>16
aaaaaaaaaaaaaaaa
Default Value
aaaaaaaaaaaaaaaa=<20>16
Valid Range and
Terms of
Command
When Power is Switched Off
The set parameter is not maintained
Valid Range within Items
The set parameter becomes valid until the next specification is
made
Valid Range between Items
The set parameter becomes invalid
[Function]
To specify Job Name for status return
[Format]
<WK>aaaaaaaaaaaaaaaa
●Parameter
a {Job Name} = ASCII Code 16 digits, shift JIS Kanji 8 digits
[Coding Example] Job Name:SATO
<A>
<WK>SATO
<V>200<H>100<P>0<$>B,100,100,6
<$=>SATOPRINTER
<Q>2
<Z>
[Supplementary Explanation]
1.If status 4 is used on interface protocol, the specified Job Name can be set at the telegraphic status.
2.Confirm the status at every ouput of status request (ENQ)
3.Program it within items and use it while printing is performed by using Data Send Start Specification <A> ~ Data Send Complete
Specification <Z>.
4.Can be used by combining with Job ID No Specification <ID>.
[Point]
1． At the status return interface protocol , it is valid if status request (ENQ) is received during printing (QTY≠0, includes Offline,
error).
2． At the status return interface protocol, if status request (ENQ) is received not during printing (QTY=0, received data is not
available
when power is switched on), set the space (20H) at the status and then return it.
3． Within the Data Send Start Specification <A> ~ Data Send Complete Specification <Z>, the final specified value becomes valid
when Job Name Specification <WK> is used more than twice.
4． The details can be referred to the “Interface Specification”.
Job Name